 |
|
 |
Find Forklifts in and around Yorkshire Yorkshire Forklifts Listing - Lex Harvey Ltd |
Top Tip - If you are considering purchasing a new or used forklift it is a good idea to look at 3 or 4 similar forklifts and compare the price of each forklift before you make your final decision.

This page gives you contact information for Lex Harvey Ltd based in Leeds and also provides you with information and impartial advice about Forklifts in and around Yorkshire that we hope you will find useful.
Lex Harvey Ltd
Treefield Ind Est Gildersome
Leeds
Yorkshire
LS27 7JU
Tel: 0113 2537051
Lex Harvey Ltd is a forklift dealer operating in and around areas of Yorkshire, specialising in the supply of new, used and refurbished forklifts for sale, lease or contract hire.
The Forklift Network can help you to find a wide range of forklifts from dealers in and around Yorkshire.- click here to search >>
|
|
If you have come to our website to find Forklifts in and around Yorkshire then we would like to give you some tips.
Whilst looking for Forklifts in and around Yorkshire remember that two of the most important safety aspects are vehicle stability and control of the load. Statistics prove that machine tip-over's and falling loads are the two biggest causes of accidents and injuries.
While you are researching Forklifts in and around Yorkshire be aware that a second hand electric forklift could have a battery with a bad cell. This does not always mean that the battery needs to be changed as it is sometimes possible to just replace the damaged cell. Replacing a single cell is much less expensive than fitting a new battery but if more than one cell needs to be replaced it is usually not cost-effective to replace them.
Whilst investigating Forklifts in and around Yorkshire remember that safety can be improved by looking for a low dashboard that allows better sight of the fork tips.
While looking for Forklifts in and around Yorkshire be aware that forks lengths vary. Long forks reduce the aisle width that the forklift can turn or right angle stack in so you need to be sure that you match the fork length to the intended use.
|
|
 |